COMPOSITE RIGHT HUB CARRIER - 4° DEG. - GRAPHITE (ECS)
Brand:
The 4° composite right steering block from Xray (ref. 302383) is a precision piece designed for drivers seeking maximum performance in their 1/8 Off-Road buggy. Made of graphite-reinforced composite material, this component offers superior rigidity and a noticeable weight reduction compared to standard versions, translating every geometry adjustment into a more direct and predictable response on the terrain.
4° caster angle: specific configuration to enhance cornering stability and ensure even tire wear.
Graphite composite material: high impact resistance and lighter weight than conventional metal parts.
Direct compatibility with Xray's range of 1/8 Off-Road buggies, ensuring installation without modifications.
Read moreShow less
€10.14
Reference:
302383
- Delivery in 24–72h.
- 100% Secure Payment
The 4° composite right C-hub carrier of Xray (ref. 302383) is a precision part designed for drivers seeking maximum performance in their 1/8 Off-Road buggy. Made of graphite-reinforced composite material, this component offers superior rigidity and a noticeable weight reduction compared to standard versions, translating every geometry adjustment into a more direct and predictable response on the terrain.
- 4° kingpin inclination: specific configuration to enhance cornering stability and achieve even tire wear.
- Composite material with graphite: high impact resistance and lighter weight than conventional metal parts.
- Direct compatibility with the range of 1/8 Off-Road buggies from Xray, ensuring an installation without modifications.
- Competition finish: tight tolerances for consistent and reproducible steering geometry in every session.
- Manufacturer reference 302383, facilitating exact identification in orders and maintenance.
16 other products in the same category:
Reference: 301213
€19.80
The 2.5mm graphite upper bumper support for the Xray T4 is a precision part designed for drivers seeking maximum performance on the track. Made of high-density graphite fiber, this component enhances the structural...
Reference: 305136
€26.12
The aluminum output cups for rigid axle Xray (ref. 305136) are precision components designed to maximize power transmission in 1/8 scale On-Road competition cars. Manufactured from high-strength aluminum, they offer...
Reference: 305434
€22.14
The low friction 3×513 Low Friction Belt by Xray (ref. 305434) is the transmission solution designed to maximize performance in Off-Road competition. Made with high-quality materials, it minimizes energy losses in the...
Reference: 305447
€20.02
The low friction rear belt 3 x 189 from Xray (ref. 305447) is a precision piece designed to maximize the performance of your On-Road chassis. Made with high-quality materials, it reduces energy losses in the rear...
Reference: 307216
€8.29
The suspension pins for the Xray T4'14 are essential components that ensure maximum precision in chassis adjustment and behavior. Manufactured to XRAY's quality standards, these pins offer exceptional durability in...
Reference: 302803
€9.52
Achieve greater front stability in your On-Road car with this 1.3mm stabilizer bar for Xray bearings. Specifically designed for bearing setups, this anti-roll bar allows you to finely tune the chassis behavior in...
Reference: 305380
€5.76
Fine-tune each turn with the Xray 0.75mm Offset Alu T2 Washer Set, the essential accessory for precisely adjusting your 1/10 On-Road car's geometry. Made from high-quality aluminum, these washers allow you to easily...
Reference: 306530
€12.97
The 3.0mm carbon stiffener plate T4'17 from Xray is the perfect complement to maximize the structural rigidity of your chassis. Specifically designed for the Xray T4'17, this high-quality carbon piece significantly...
