REAR LOWER CONTROL ARM SUPPORT - FRONT - BRASS
Brand:
The Front Lower Inner Pivot Pin Holder in Brass by Xray (ref. 323312) is a precision part designed for drivers seeking maximum geometric performance in their 1/10 Off-Road RC models. Made of high-density brass, this holder adds strategically placed extra weight to the rear axle, improving traction and stability without compromising the suspension response on rough terrain.
- High-density brass material: increased weight concentrated at the lower part of the chassis for a lower center of gravity and improved grip.
- Precise suspension geometry: tight tolerances ensuring a consistent setup race after race.
- Compatibility with 1/10 Off-Road Xray models: direct fit without modifications.
Read moreShow less
€38.95
Reference:
323312
- Delivery in 24–72h.
- 100% Secure Payment
The Front Lower Rear Brass Suspension Holder for Xray (ref. 323312) is a precision part designed for drivers seeking maximum geometric performance in their 1/10 Off-Road RC models. Made from high-density brass, this holder provides strategically placed additional mass in the rear axle, enhancing traction and stability without compromising suspension response on rough terrains.
- High-density brass material: increased weight concentrated in the lower chassis area for a lower center of gravity and improved grip.
- Precise suspension geometry: tight tolerances ensuring consistent setup race after race.
- Compatibility with 1/10 Off-Road Xray models: direct fit without additional modifications.
- Superior wear resistance: brass offers greater durability against impacts and abrasion typical in competition.
- Manufacturer reference 323312: official Xray identification for quick and error-free replacement.
- Enhanced rear balance: ideal for setup adjustments on technical tracks demanding optimal weight distribution.
16 other products in the same category:
Reference: 322571
€7.13
The Composite Servo Saver Base Xray (ref. 322571) is an essential component to keep your servo properly seated and protected under demanding competition conditions. Made of high-strength composite material, this base...
Reference: 321211
€14.15
The ALU lower front suspension holder from Xray allows precise adjustment of the front geometry of your competition RC car. Made of high-quality aluminum and available in 23° and 29° angles, this 3mm reinforcement...
Reference: 322110-H
€7.88
The Xray front lower suspension arm (ref. 322110-H) is a high-performance replacement part designed for drivers seeking increased structural rigidity in their 1/8 Off-Road platform. Made with top-quality materials,...
Reference: 323015
€22.87
The Mid Motor Gearbox (3 Gears) Set from Xray is the ultimate solution for drivers looking to maximize the performance of their transmission in 1/10 On-Road chassis with a mid-motor configuration. Designed with Xray's...
Reference: 323015-G
€37.21
The 3-Gear Mid Motor Gear Box in Graphite from Xray (ref. 323015-G) is the transmission solution designed for drivers looking for maximum precision and reliability in competition with 1/10 On-Road touring cars. Its...
