FRONT SUSPENSION ARM - LSM - RIGHT - SHORT - HARD
Brand:
The right front suspension arm LSM Short Hard from Xray is a precision component designed for drivers seeking maximum control on off-road tracks. This short hard piece provides direct response and superior stability on technical terrains, significantly improving the performance of your competition chassis.
- Optimized LSM Design: State-of-the-art suspension system that reduces weight transfer
- High-strength hard material: Withstands extreme impacts without permanent deformation
- Short length: Increases response speed and precision in tight turns
- Certified compatibility: Perfect fit with Xray chassis (Ref. 322117-H)
- Competition durability: Manufactured with precision tolerances for consistent performance
- Traction improvement: Specialized geometry for rugged terrains and uneven surfaces
16 other products in the same category:
Reference: 323382
€17.22
Reference: 322220-M
€7.88
The left wheel hub carrier Xray 322220-M is a suspension part designed to ensure precise and consistent lateral guiding in competition Off-Road buggies. Made with high-strength materials, this component withstands the...
Reference: 323351
€36.02
The aluminum rear upright from Xray (ref. 323351) is a high-performance replacement part made of Swiss 7075 T6 alloy, one of the strongest materials available in the competitive RC market. Specifically designed for...
Reference: 323320
€40.00
The delayed lower rear aluminum support from Xray (ref. 323320) is a precision part designed for drivers who demand the maximum performance from their chassis on the track. Manufactured from high-quality aluminum,...
Reference: 322280
€8.60
The Excentricas Caster (2+2+2) from Xray allow you to precisely adjust the steering caster angle on your 1/10 On-Road cars, providing complete control over the front geometry to adapt it to each track and race...
Reference: 322550
€14.15
The Aluminum Servo Saver Shaft Xray (ref. 322550) is an essential component to protect the steering servo under demanding competition conditions. Made of high-strength aluminum, this shaft acts as a mechanical fuse,...
Reference: 323328
€33.62
Rear suspension support made of Swiss 7075 T6 aluminum for your XRAY XB2 '22 1/10 Off-Road. This competition component provides the necessary stiffness to fine-tune the geometry and dynamic behavior of your vehicle on...
Reference: 327210
€6.04
The Xray front suspension arm pin is an essential spare part to maintain the correct geometry in the front end of your 1/10 scale RC competition car. Manufactured with high-precision materials, it ensures consistent...