ALU STEERING BLOCKS WITH GRAPHITE EXTENSION PLATES
Brand:
The aluminum steering blocks Xray ref. 302202 with graphite extension plates represent the ultimate solution to enhance the precision and stiffness of your competition RC chassis. Designed for maximum stability in corners, these components offer exceptional track control, allowing you to unleash the full potential of your vehicle in high-level races.
- High-quality aluminum blocks with superior stiffness
- Graphite extension plates to reduce weight without compromising strength
- Improved steering precision at all speeds
- Compatible with the latest generation Xray chassis
- Manufacturer reference: 302202
- Direct installation without additional modifications
16 other products in the same category:
Reference: 309854
€33.31
The 30g central chassis balance weights from Xray are essential components for fine-tuning the center of gravity of your RC model. These weights allow you to adjust the weight distribution with surgical precision,...
Reference: 303364
€8.29
The rear hubs Xray 303364 with 0° convergence geometry and 1-hole configuration (Hard) are designed for drivers seeking maximum precision and stability in the rear steering of their 1/8 Off-Road buggy. Made of...
Reference: 301145
€122.63
The 2.2mm graphite Xray T4'18 chassis is a high-performance replacement part designed for drivers looking to push their 1/10 On-Road car to the limit. Made of high-density graphite fiber, it offers superior rigidity...
Reference: 305137
€33.97
The front rigid axle shafts Xray 305137 are made of high-quality Hudy steel, the benchmark material in the world of RC competition. Designed to provide precise and efficient power transmission in the front end, these...
Reference: 308288
€11.80
The Xray T4 4S 2.8 springs are essential components to fine-tune the suspension of your 1/10 scale competition RC car. With a stiffness of 2.8, these springs offer the perfect balance between grip and stability on...
Reference: 303362
€8.29
The rear hubs Xray 303362 are designed for competition drivers seeking maximum control over the rear geometry of their 1/10 On-Road Touring car. Featuring 0º toe-in and a 1-hole Medium version setup, these parts allow...
ALUM. BANCADA CARRADO I/D. - ORANGE T4-18 This translates to: ALUM. BENCH LOCKED L/R. - ORANGE T4-18
Reference: 303001-O
€18.33
The aluminum support for the Xray T4-18 chassis (ref. 303001-O) is a precision piece designed to reinforce the structural rigidity of the chassis and improve the vehicle's dynamic response on the track. Made of...
Reference: 302293
€5.76
The nylon bushings for C-Hub uprights Xray (ref. 302293) are an essential component to maintain the precision and performance of the steering in your 1/10 scale on-road cars. Made of high-strength nylon, these...
Reference: 308364
€17.69
The hardened T4 drive shafts from Xray are essential components for drivers looking to maximize the stiffness and durability of their chassis. Specifically designed for the T4 1/10 Off-Road model, these drive shafts...
