T4''20 ULP GRAPHITE FRONT SHOCK TOWER 3.0MM - LOW
Brand:
The Graphite Front Shock Tower 3.0mm LOW for the Xray T4'20 is the perfect solution to adjust the front stiffness of your 1/10 On-Road. Made from high-quality graphite material, it provides controlled flexibility that significantly enhances chassis response in fast corners and transitions. Ideal for drivers looking to maximize grip and stability in competition.
- Graphite material of 3.0mm with low stiffness for greater track sensitivity
- Fully compatible with Xray T4'20 (Ref. 301961)
- Improves front end response during direction changes
- Increases grip in technical and high-speed corners
- Allows fine-tuning of chassis geometry and behavior
- Essential replacement part for maintenance and customization
16 other products in the same category:
Reference: 303710-O
€14.81
The aluminum lower suspension holder from Xray for the T4'14 and T4'15 models is a replacement and upgrade part designed for drivers who demand maximum performance on the track. Made of high-quality aluminum, this...
Reference: 302361
€8.29
The right steering hub with -2° inclination from Xray is a replacement part designed to precisely adjust the steering geometry on your competition Off-Road chassis. Made with high-strength materials, this medium-grade...
Reference: 302612-O
€15.05
The 39mm M3 L/R Inverted Thread Axle Shaft from Xray (ref. 302612-O) is a precision transmission piece designed for drivers who demand maximum performance from their On-Road chassis. Manufactured with minimal...
Reference: 307222
€11.67
The front trapezoidal pins Xray 307222 Titan are precision suspension components designed to maximize the performance of your 1/10 on-road chassis. Made of the highest quality hardened steel, these pins ensure agile...
Reference: 302711
€35.86
The one-piece front lower suspension mount made of brass from Xray is designed for drivers seeking maximum precision and stability in their competition FF chassis. The monoblock construction eliminates unnecessary...
Reference: 303123-O
€8.29
The 3x6x2 orange aluminum washers (ref. 303123-O) are the perfect complement to ensure precise and durable assembly in your competition RC car. Made of high-quality aluminum with an anodized orange finish, they offer...
Reference: 302335
€60.35
The 2° angled aluminum right-side steering block from Xray (ref. 302335) is a precision replacement part designed to maximize the performance of your 1/8 Off-Road buggy on the track. Made from high-quality aluminum...
Reference: 303804
€9.52
The 1.4mm rear stabilizer bar from Xray is a precision component designed for drivers seeking maximum control over the rear of the chassis. Made of high-strength steel, it allows for precise adjustment of the rear end...
Reference: 308376
€11.29
The Xray SPRING SET-C 2.8 (2) is the perfect solution for adjusting the suspension of your competition RC vehicle. This set of two springs is designed for demanding drivers looking to improve dynamic behavior and...
