TRAPEZOID BACK SUSPENSION ARS - ACTIVE - GRAPHITE - 1-HOLE
Brand:
The ARS Active rear suspension arm from Xray in graphite material is a precision piece designed for drivers seeking maximum performance in 1/10 On-Road competition. Crafted from high-quality graphite, this component offers exceptional rigidity combined with reduced weight, key factors for improving suspension response and stability in corners. Its 1-hole configuration allows for specific adjustment of the rear geometry, catering to the demands of each track. Competitive graphite material: high structural rigidity with minimal weight for more precise suspension dynamics.
1-hole design: single anchor point configuration for a defined and consistent rear geometry.
ARS Active system
Read moreShow less€11.55
Reference:
303171
- Delivery in 24–72h.
- 100% Secure Payment
The ARS Active rear suspension arm from Xray in graphite material is a precision part designed for drivers seeking maximum performance in 1/10 On-Road competition. Manufactured with high-quality graphite, this component offers exceptional rigidity combined with reduced weight, key factors to improve suspension response and cornering stability. Its 1-hole configuration allows for specific adjustment of the rear geometry, adapting to the demands of each track.
- Competition-grade graphite material: high structural rigidity with minimal weight for more precise suspension dynamics.
- 1-hole design: single anchor point configuration for a defined and consistent rear geometry.
- ARS Active system: direct integration with the rear active suspension system of the Xray chassis.
- Guaranteed compatibility: original Xray part with reference 303171, specifically designed for 1/10 On-Road models.
- Behavior improvement: contributes to greater rear stability and more direct response in braking and acceleration.
16 other products in the same category:
Reference: 302802
€9.52
The 1.2 mm front stabilizer bar from Xray (ref. 302802) is a precision component designed to adjust the stiffness of the front axle in competition On-Road RC cars. Its specific diameter allows for a balanced mix of...
Reference: 303127-K
€10.30
The aluminum washers 3x6x4.0mm from Xray (ref. 303127-K) are a precision part designed for demanding pilots seeking maximum control with every adjustment. Made of high-quality aluminum with a black anodized finish,...
Reference: 303120
€12.80
The aluminum washers Xray (ref. 303120) are the essential complement to precisely adjust the geometry and clearance of your drivetrain. Available in three thicknesses — 0.5 mm, 1.5 mm, and 2.5 mm — they allow for...
Reference: 301218
€7.64
The Bumper Upper Support Xray (Ref. 301218) is a precision part designed to reinforce and properly anchor the front bumper on 1/10 Off-Road chassis from the Xray range. Manufactured to the quality standards of the...
