Reference: 308090
€7.64
Set of 4 foam inserts for shock absorbers specifically designed to improve damping in 1/10 Off-Road Xray vehicles. These components allow for precise adjustment of the shock absorbers' response, providing a more...
ALU SHOCK CAP-NUT WITH VENT HOLE - BLACK (2)
Brand:
The ventilated aluminum cap nuts Xray (ref. 308352-K) are essential components for precisely adjusting your RC shocks. Specifically designed for 1/8 and 1/10 Off-Road models, these nuts provide complete control over the stiffness and response of your suspension in competition.
- High-strength black anodized aluminum construction
- Ventilation holes that enhance thermal dissipation of the shock fluid
- Compatible with standard 1/8 and 1/10 Off-Road shocks
- Supplied in packs of 2 units for both sides of the rear end
- Allows fine stiffness adjustments without changing the shock oil
- Professional quality finish, tested in competition
16 other products in the same category:
Reference: 305390
€6.49
The ECS Short Universal Joint Drive Shaft Pin for Xray (ref. 305390) is a precision transmission part designed to maximize the performance of your competition RC chassis. Made from high-strength materials, this pin...
Reference: 305380
€5.76
Fine-tune each turn with the Xray 0.75mm Offset Alu T2 Washer Set, the essential accessory for precisely adjusting your 1/10 On-Road car's geometry. Made from high-quality aluminum, these washers allow you to easily...
Reference: 301213
€19.80
The 2.5mm graphite upper bumper support for the Xray T4 is a precision part designed for drivers seeking maximum performance on the track. Made of high-density graphite fiber, this component enhances the structural...
Reference: 301198
€49.03
The Top Deck 2.0mm Carbon V2 from Xray (ref. 301198) is a high-performance tuning part designed to enhance the dynamic response of your 1/10 On-Road chassis. Made from high-quality carbon fiber, this second-generation...
Reference: 302336
€66.38
The ALU 2° left steering block from Xray (ref. 302336) is a precision suspension part designed for drivers who demand maximum performance in Off-Road competition. Manufactured from high-quality aluminum with an orange...
Reference: 302370
€8.29
The Xray left composite caster block in 0° caster angle (Hard) version is a suspension part designed for drivers seeking maximum steering response precision in their 1/10 On-Road cars. Made of high-stiffness composite...
Reference: 305353
€18.29
Adjust the geometry of your Xray 1/10 with millimetric precision thanks to this wheel hub made of machined aluminum with a +1.5 mm offset. Designed for drivers looking for that extra bit of track width, this component...
Reference: 303431-K
€10.90
The 5mm aluminum T2 rod ends from Xray are precision components designed to deliver optimal performance in 1/10 On-Road RC cars. Made of high-strength aluminum, these rod ends offer precise steering response and...
Reference: 308315
€8.29
The long shock absorber ball joints Xray 308315 are essential components for adjusting the geometry and response of your 1/8 Off-Road chassis. This set of 4 pieces made of high-strength material allows you to optimize...
Reference: 305434
€22.14
The low friction 3×513 Low Friction Belt by Xray (ref. 305434) is the transmission solution designed to maximize performance in Off-Road competition. Made with high-quality materials, it minimizes energy losses in the...