T4''20 ANTI-ROLL BAR FOR BALL-BEARINGS - FRONT 1.4
Brand:
Enhance the performance of your Xray T4 1/10 On-Road with this front anti-roll bar made of 1.4mm specifically designed for bearing systems. Achieve perfect balance in fast corners and master race lines with pinpoint accuracy. The anti-roll bar reduces roll during corner entry, providing stability without sacrificing the T4's characteristic agility.
- Diameter: 1.4mm - optimized geometry for maximum control
- Compatible with front bearings of the Xray T4 1/10
- Reduces roll-over in corners keeping you competitive
- High-strength material for durability during intense training
- Official Xray reference: 302814
- Easy installation on the front hub
16 other products in the same category:
Reference: 302610
€15.05
The adjustable straps Xray 302610 are designed for pilots seeking maximum control over the geometry of their 1/10 On-Road chassis. With a length of 40 mm and supplied in pairs, these components allow precise tuning of...
Reference: 302712-O
€24.80
The aluminum front lower suspension arm from Xray is a precision part designed to enhance the geometry and front end response in 1/10 scale On-Road and Touring cars. Crafted from high-quality aluminum, this component...
Reference: 305447
€20.02
The low friction rear belt 3 x 189 from Xray (ref. 305447) is a precision piece designed to maximize the performance of your On-Road chassis. Made with high-quality materials, it reduces energy losses in the rear...
Reference: E0105
€5.95
EliteBlack is a high-performance grease specifically formulated for the demands of competitive RC models, both on-road and off-road. Its advanced composition ensures precise and long-lasting lubrication in the most...
Reference: 305380
€5.76
Fine-tune each turn with the Xray 0.75mm Offset Alu T2 Washer Set, the essential accessory for precisely adjusting your 1/10 On-Road car's geometry. Made from high-quality aluminum, these washers allow you to easily...
Reference: 302662
€7.31
The 5 mm open configuration nylon ball joints from Xray are an essential component to maintain the geometric precision of your RC car in competition conditions. Their open design makes it easy to install and quickly...
Reference: 304970
€26.12
Improve the response and reliability of your differential with the Aluminum Differential Case Xray for the T-3 chassis. Made of high-quality aluminum, this component offers superior rigidity compared to the standard...
Reference: 303054-O
€18.26
The machined aluminum chassis braces Xray T4 (ref. 303054-O) are the ideal upgrade for drivers looking for increased structural rigidity in their 1/10 On-Road competition chassis. Made of high-quality aluminum with a...
Reference: 308354-O
€11.80
Significantly improve the suspension performance of your Xray T4 18 with these narrow version aluminum shock caps. Specifically designed for 1/10 on-road vehicles, these components offer a lightweight and robust...
Reference: 308275
€11.80
The Xray T4 4S 2.5 springs are essential components for fine-tuning the dynamic behavior of your T4 1/10 on-road chassis. Precision-designed in the laboratory, these springs offer the exact stiffness you need to...
Reference: 302620
€9.59
The 22mm adjustable suspender straps are precision parts designed for demanding drivers looking for maximum control over the geometry of their On-Road chassis. Its symmetrical design, compatible with both left and...
Reference: 302611
€15.05
The adjustable 35mm Xray 302611 braces are essential components for precisely tuning the suspension geometry on Xray 1/10 On-Road chassis. Manufactured with high-strength materials, they allow for reliable...