Reference: 303172
€53.80
The ALU 1-HOLE rear sway bar mount from Xray, made of SWISS 7075 T6 alloy, is the ultimate solution for drivers seeking maximum stability and precision in on-road competition. This high-end component provides direct...
T4''20 ALU FRONT LOWER 1-PIECE SUSPENSION HOLDER -
Brand:
The front lower suspension support for the T4'20 from Xray represents the ultimate solution for drivers demanding maximum rigidity and precision in competition. Made from a single piece of aluminum, this component ensures a direct and consistent force transfer, eliminating unwanted flex that could affect chassis response. Its monolithic design optimizes the front geometry behavior in every corner and acceleration.
- Monolithic aluminum construction: Greater rigidity and durability compared to conventional plastic options
- Guaranteed dimensional precision: Tight tolerances for a perfect fit on the T4'20
- Direct suspension improvement: More effectively transmits adjustment changes to the overall behavior of the car
- Manufacturer reference 302723: Original component approved by Xray for maximum compatibility
- Impact resistance: Withstands the demands of the track without compromising mechanical precision
- Bounce effect reduction: Stabilizes the front suspension during intense braking and acceleration
16 other products in the same category:
Reference: 303129
€5.00
The axle width shims Xray (part number 303129) are fine adjustment pieces designed to achieve exact geometric configuration on your transmission axles. The pack includes two units in 1×3 mm and 1×2 mm sizes, allowing...
Reference: 305977
€14.39
The Hardened Aluminum 27T / 64 Pinion Gear from Xray (ref. 305977) is a high-performance transmission piece designed for demanding RC competition. Made from hardened aluminum, it offers superior rigidity and...
Reference: 301324
€8.89
The Front Body Support Set +2mm from Xray (ref. 301324) is the ideal solution for precisely adjusting the body support in touring and on-road models from the brand. This set allows for slightly raising the front...
ALUM. BANCADA CARRADO I/D. - ORANGE T4-18 This translates to: ALUM. BENCH LOCKED L/R. - ORANGE T4-18
Reference: 303001-O
€18.33
The aluminum support for the Xray T4-18 chassis (ref. 303001-O) is a precision piece designed to reinforce the structural rigidity of the chassis and improve the vehicle's dynamic response on the track. Made of...
Reference: 305224
€25.66
The 52mm ECS driveshaft from Xray is a precision part designed for drivers who demand maximum performance in on-road competition. Made from high-strength materials, this driveshaft ensures efficient and smooth power...