Valencia orange lexan paint spray 150ml XTR

Polycarbonate bodies

Trim the body and sand the edges where you made the cut.

Many bodies have a clear protective film on the outside. Don't remove it until the paint is completely dry!

Cover with masking tape or masking film all areas you don't want to paint.

Always start by painting dark colors before light ones to avoid the darker tones showing through the lighter ones.

Before painting, make sure the surfaces are clean, dry, and dust-free.

For best results

Before using the spray, shake it vigorously for about 2 minutes until you hear the mixing ball.

Spray the paint from a distance of about 20 to 30 cm and make even cross movements with the spray.

The coverage ability of colors for RC cars may vary slightly between shades.

Always apply very thin coats to avoid the paint running. The optimal result is achieved after applying 2 to 3 coats. Wait about 5 minutes between each coat.

Don't apply a single thick coat!

Let the paint dry for 5 minutes before removing the masking tape or film and applying the next coat.

After using the spray, turn it upside down and spray for 2 seconds to clean the nozzle.

Specific instructions for fluorescent colors

Fluorescent colors tend to cover less than conventional colors. It's crucial to apply only very light coats.

Use these colors only when the temperature is above 15°C.

Apply from a distance of about 15 to 20 cm.

Let the color dry for 30 minutes and then apply a coat of white  XTR Colour as a base.

Only then will you achieve the desired fluorescent effect!

Content:

150 ml